SWITCHED-BEAM ARRAY ANTENNA AT 28 GHZ FOR 5G WIRELESS SYSTEM BASED ON BUTLER MATRIX BEAMFORMING NETWORK
Keywords:
Array antenna, Butler matrix, millimetre wave, switched-beam antenna, 5GAbstract
This work presents a compact, switched-beam array antenna on 4 × 4 Butler Matrix (BM) beamforming network (BFN) at 28 GHz for fifth generation (5G) wireless system. A single layer has been chosen to ensure low cost and ease fabrication. The four input ports of the designed antenna have the capability of producing four independent directional beam patterns at 13.8°, -43.5°, 44° and -14°, when P1, P2, P3 and P4, respectively are excited. The radiation efficiency obtained from each of the four ports is well above 80% at the designated frequency. The peak antenna gain of 15.9 dBi is obtained at port 1 and 4. The design is verified by measurement and all results have a good correlation with simulation.
Downloads
Published
Issue
Section
License
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from http://nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in http://nijotech.com/downloads/Statement%20of%20Originality.pdf
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.