GIS-BASED HYDROLOGICAL MODELLING USING SWAT: CASE STUDY OF UPSTREAM WATERSHED OF JEBBA RESERVOIR IN NIGERIA
DOI:
https://doi.org/10.4314/njt.333.831Keywords:
GIS, Hydrologic Modeling, Jebba Reservoir, Nigeria, SWAT ModelAbstract
Hydrological modeling tools have been increasingly used worldwide in the management of water resources at watershed level. The application of these tools have been improved in recent time through the advent of remote sensing and Geographical Information System (GIS) techniques which enhance the use of spatially and physically based models to simulate and predict some of the major functions of watershed systems. In this study, the focus was on the applicability and feasibility of SWAT model interfaced with GIS software (MapWindow) in the prediction of stream flow of a watershed located upstream of Jebba reservoir in Nigeria. The flow predictions by SWAT were calibrated (from Jan. 1990 to Dec. 1992) and validated (from Jan.1993 to Dec.1995) against measured flow data while the performance evaluation of the model was achieved using coefficient of determination R2 and Nasch-Sutcliffe Efficiency (NSE). Sensitivity analysis of the model parameters showed that curve number is the most sensitive parameter for estimation of stream flow within the catchment. The model results showed a good correlation with the observed data with values of 0.76 for R2 and 0.72 for NSE during calibration period. For validation periods, R2 and NSE values were 0.71 and 0.78 respectively. This interesting results of SWAT is an indication that a properly calibrated SWAT can be an ideal modeling tool for supporting water resources management policies and decisions at watershed level in the region and other river catchments in Nigeria
Downloads
Issue
Section
License
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from http://nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in http://nijotech.com/downloads/Statement%20of%20Originality.pdf
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.