PREPARATION AND CHARACTERIZATION OF ACTIVATED CARBON FROM BEAN HUSK

Authors

  • ET Evwierhoma DEPARTMENT OF CHEMICAL ENGINEERING, UNIVERSITY OF LAGOS, AKOKA, LAGOS STATE, NIGERIA
  • OD Madubiko DEPARTMENT OF CHEMICAL ENGINEERING, UNIVERSITY OF LAGOS, AKOKA, LAGOS STATE, NIGERIA
  • A Jaiyeola DEPARTMENT OF CHEMICAL ENGINEERING, UNIVERSITY OF LAGOS, AKOKA, LAGOS STATE, NIGERIA

Keywords:

Bean husk, Activated carbon, optimum temperature, impregnation ratio, Activating agent

Abstract

The optimal process conditions for the preparation of activated carbon from bean husk were investigated in this study. Four chemical activating agents; potassium hydroxide (KOH), sulphuric acid (H2SO4), zinc chloride (ZnCl2), and ortho-phosphoric acid (H3PO4) were used to activate the carbon. The influence of these agents on the surface area and porosity of activated carbon was determined. The Iodine numbers of 894.65, 1027.69, 1218.24 and 1256.31mg/g were found for the KOH, H2SO4,ZnCl2 and H3PO4activated carbons respectively. This indicates that the one prepared using ortho- phosphoric acid (H3PO4) produced the best activated carbon. The influence of activation temperature was studied between 500oC and 900oC. The effect of activation temperature shows an optimum temperature of 700oC at the time of 30mins. Further studies revealed that the best impregnation ratio of carbon to ortho-phosphoric acid was 10:5as it gave a maximum iodine number of 1288.926.The results of the characterization show that the values of apparent density, ash content, moisture content and pH of the activated carbon fall within the range recommended by ASTM. This activated carbon is suitable for the treatment of effluent water and gases.

 

http://dx.doi.org/10.4314/njt.v37i3.17

Downloads

Published

2018-07-01

How to Cite

Evwierhoma, E., Madubiko, O., & Jaiyeola, A. (2018). PREPARATION AND CHARACTERIZATION OF ACTIVATED CARBON FROM BEAN HUSK. Nigerian Journal of Technology, 37(3), 674–678. Retrieved from https://www.nijotech.com/index.php/nijotech/article/view/1769

Issue

Vol. 37 No. 3 (2018)

Section

Chemical, Industrial, Materials, Mechanical, Metallurgical, Petroleum & Production Engineering

License

The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.

NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.

A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from http://nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in http://nijotech.com/downloads/Statement%20of%20Originality.pdf

 

For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.

 

It is forbidden to publish the same research report in more than one journal.