PRODUCTION OF PARTICLE BOARDS USING POLYSTYRENE AND BAMBOO WASTES
DOI:
https://doi.org/10.4314/njt.363.1392Keywords:
bamboo waste Particleboard, , polystyrene based resin polystyrene waste.Abstract
This investigation was able to produce incredibly strong particleboards using bamboo and resinous material obtained from Polystyrene wastes. The particleboards were prepared by mixing the bamboo fibres and Polystyrene based resin (PBR) followed by flat press process at different ratio (v/v). Physical properties were measured, with reference to normal and oven curing methods, according to the ASTM D-1037 standard. Thickness Swelling (TS) of the samples were measured after 2 and 24 hours of immersion in water at 25oC temperature. It was found that the physical properties of particleboards with 20%, 30% and 40% PBR content were all in agreement with low density particleboard classification of American National Standards Institute (ANSI). TS increased as the PBR content decreased in the matrix. Obtained properties convincingly indicate superior bonding ability of the synthesised resinous polystyrene over known industrial adhesives typically used for particleboard production.
http://dx.doi.org/10.4314/njt.v36i3.18
Downloads
Published
Issue
Section
License
The contents of the articles are the sole opinion of the author(s) and not of NIJOTECH.
NIJOTECH allows open access for distribution of the published articles in any media so long as whole (not part) of articles are distributed.
A copyright and statement of originality documents will need to be filled out clearly and signed prior to publication of an accepted article. The Copyright form can be downloaded from http://nijotech.com/downloads/COPYRIGHT%20FORM.pdf while the Statement of Originality is in http://nijotech.com/downloads/Statement%20of%20Originality.pdf
For articles that were developed from funded research, a clear acknowledgement of such support should be mentioned in the article with relevant references. Authors are expected to provide complete information on the sponsorship and intellectual property rights of the article together with all exceptions.
It is forbidden to publish the same research report in more than one journal.
How to Cite
